-->

How to Install Windows 7 From your PEN-DRIVE

Required Software

PENDRIVE [minimum capacity 4 GB]

1^st- Step

Insert your PEN DRIVE

Type CMD on RUN Command & Open Command Prompt.

If you are using Windows 7/Vista then open it with administrator rights.

Go to Start -> All Programs -> Accessories -> Right-click on “Command Prompt” and select “Run as Administrator”.

2^nd-Step

In the command prompt, type in the following command:

DISKPART

This will start the Microsoft DiskPart utility as shown below:

3^rd-Step

Now issue the following command:

LIST DISK

This will show you a list of  available disks on your system. Disk 0 is usually the hard disk. In my case, Disk 5 is the PEN drive (this can be a different one in your case). Now issue the command as shown below:

SELECT DISK 5

NOTE: In the above command, 5 is the PEN drive number on my system. If you have a different number on your system, then you need to replace 5 with that number.

4^th-Step

Now issue the following list of commands one by one as shown below:

CLEAN

CREATE PARTITION PRIMARY
SELECT PARTITION 1
ACTIVE
FORMAT FS=NTFS QUICK
ASSIGN
EXIT

Minimize the command prompt and proceed to the next step.

5^th-Step

Insert the Windows 7/Vista installation disc and note down the “drive letter” of your DVD drive. In my case, it is “H:”. Now type the following list of commands as shown below:

H: CD BOOT

CD BOOT

BOOTSECT.EXE /NT60 M: (NOTE: M: is your PEN drive letter)

EXIT

6^th-Step

Copy the contents of your Windows 7/Vista installation disk into the PEN flash drive.

That’s it! Your PEN stick is now ready to boot and install the OS for you. Don’t forget to enable the “PEN Boot” option and change the “boot priority to PEN device from hard disk” in your BIOS

-->

Thanks

RAJ_THE_HACKER

8270859989

.